Dom Sports - everythingshuffleboard.com: BASIC RULES

MINI Roll-A-Court Vinyl 27' x 54"
Code: CRM-07

Weight: 20 lbs.
Size: 27 feet x 54 inches
Boxed size: 58" x 7" x 7"
Colour: Dark Green

This is a recreational, fun court, perfect in places where space is a premium.

Easy to transport and roll out and easy to store when finished playing - only 20lbs. No assembly required - simply roll out and play. (Rolling out on hard flat surfaces is recommended).

Made of vinyl, the Mini Court measures 27' long x 54" wide. You need to have a space of 39' however to allow 6' on each end to shoot from. Use full size discs and cues and play just about anywhere. Silicone spray is included with the court and helps discs glide more easily.

Family, School, Church and Community Centre fun. Play on driveway, porch, patio, garage, gym, basement or tennis court.

* The regular Pro ARCO discs (OTD) will not work well on the roll out courts because they tend to "push" the beads out of the way. The special discs (OTD-B), also ARCO brand, are specially bevelled, so that they glide over the beads properly.

CARE OF ROLL-A-COURT

The Roll-A-Court is made of an extremely flexible Vinyl/Rubber composition and is custom colored and embossed. The thickness is less than 1/8" inch. Size is 54"x 27’ and the lines are painted white.

One thing you must be careful of: When rolling court on core leave some core at each end and line up core with deadline on court so it is straight across.

Start to roll and make sure corners are tucked in properly or they will fold over.

Proceed to roll to other end, and if court is not even stand on end that has core showing, hold onto loose end, let some air get in and court will slide to floor. Then tighten and tape middle and each end with duct tape.

When placing in tube keep loose end of court facing up so it does not fold over.

Use plastic beads sparingly, and save by collecting and runnig through a window screen to remove dirt and re-use. Glass beads of a good quality can be used (not recommended), but may require sealer applied more often as it contains some broken glass, and you must ensure that the sealer does not wear off or the surface will wear/cut and shorten life of the court.

Depending on use, courts must have a thin coat of Nella-Seal applied to protect the surface. This may be required yearly but it depends on use. Sealer is applied by shaking bottle to put a puddle on court, then spreading out with an applicator. Drying time is 4 hours to roll up and 24 hours before use.

If the Roll-A-Court is cared for properly you can expect many years of enjoyment.


	close window
	MINI Roll-A-Court Vinyl 27' x 54" Code: CRM-07 Weight: 20 lbs. Size: 27 feet x 54 inches Boxed size: 58" x 7" x 7" Colour: Dark Green This is a recreational, fun court, perfect in places where space is a premium. Easy to transport and roll out and easy to store when finished playing - only 20lbs. No assembly required - simply roll out and play. (Rolling out on hard flat surfaces is recommended). Made of vinyl, the Mini Court measures 27' long x 54" wide. You need to have a space of 39' however to allow 6' on each end to shoot from. Use full size discs and cues and play just about anywhere. Silicone spray is included with the court and helps discs glide more easily. Family, School, Church and Community Centre fun. Play on driveway, porch, patio, garage, gym, basement or tennis court. * The regular Pro ARCO discs (OTD) will not work well on the roll out courts because they tend to "push" the beads out of the way. The special discs (OTD-B), also ARCO brand, are specially bevelled, so that they glide over the beads properly. CARE OF ROLL-A-COURT The Roll-A-Court is made of an extremely flexible Vinyl/Rubber composition and is custom colored and embossed. The thickness is less than 1/8" inch. Size is 54"x 27’ and the lines are painted white. The courts have 2 coats of sealer applied. One thing you must be careful of: When rolling court on core leave some core at each end and line up core with deadline on court so it is straight across. Start to roll and make sure corners are tucked in properly or they will fold over. Proceed to roll to other end, and if court is not even stand on end that has core showing, hold onto loose end, let some air get in and court will slide to floor. Then tighten and tape middle and each end with duct tape. When placing in tube keep loose end of court facing up so it does not fold over. Use plastic beads sparingly, and save by collecting and runnig through a window screen to remove dirt and re-use. Glass beads of a good quality can be used (not recommended), but may require sealer applied more often as it contains some broken glass, and you must ensure that the sealer does not wear off or the surface will wear/cut and shorten life of the court. Depending on use, courts must have a thin coat of Nella-Seal applied to protect the surface. This may be required yearly but it depends on use. Sealer is applied by shaking bottle to put a puddle on court, then spreading out with an applicator. Drying time is 4 hours to roll up and 24 hours before use. If the Roll-A-Court is cared for properly you can expect many years of enjoyment.
	close window