Dom Sports - everythingshuffleboard.com: BASIC RULES

Full length LightWeight Roll-A-Court Vinyl 40' x 6'
Code: CRL-07

Weight: 44 lbs.
Size: 40 feet x 6 feet
Boxed size: 75" x 8" x 8"
Colour: Light Green

This court combines the full size play of the original tournament Roll-A-Court version but with a thinner vinyl that not only provides a cost savings, but allows the court to be set up with just one person.

Recommended for indoor use, it can be used outdoors. No assembly required - simply roll out and play. When finished simply sweep the surface and roll up - easily stored for your next game.

Made of vinyl, the Light Roll out Court measures a full 40' long x 6' wide. Silicone spray is not included with the court. Beads are recommended but only use plastic beads (never glass beads) and ensure no one walks on the court. (Ensure all beads are thoroughly swept up after play).

For best play the official Arco brand "bevelled" discs are strongly recommended (see below)*.

This court is ideal where there is a multi-use facility. Shuffleboard can be set up and played during its allotted time and when finished the floor can be cleared within 5 minutes - ready to use for the next scheduled event.
.

* The regular Pro ARCO discs (OTD) will not work well on the roll out courts because they tend to "push" the beads out of the way. The special discs (OTD-B), also ARCO brand, are specially bevelled, so that they glide over the beads properly.

CARE OF ROLL-A-COURT

The Roll-A-Court is made of an extremely flexible Vinyl/Rubber composition and is custom colored and embossed. The thickness is less than 3/32 inch. Size is 6’ x 40’ and the lines are painted white.

One thing you must be careful of: When rolling court on core leave some core at each end and line up core with deadline on court so it is straight across.

Start to roll and make sure corners are tucked in properly or they will fold over.

Proceed to roll to other end, and if court is not even stand on end that has core showing, hold onto loose end, let some air get in and court will slide to floor. Then tighten and tape middle and each end with duct tape.

When placing in tube keep loose end of court facing up so it does not fold over.

Use plastic beads sparingly, and save by collecting and runnig through a window screen to remove dirt and re-use. Glass beads of a good quality can be used (not recommended), but may require sealer applied more often as it contains some broken glass, and you must ensure that the sealer does not wear off or the surface will wear/cut and shorten life of the court.

Depending on use, courts must have a thin coat of Nella-Seal applied to protect the surface. This may be required yearly but it depends on use. Sealer is applied by shaking bottle to put a puddle on court, then spreading out with an applicator. Drying time is 4 hours to roll up and 24 hours before use.

If the Roll-A-Court is cared for properly you can expect many years of enjoyment.


	close window
	Full length LightWeight Roll-A-Court Vinyl 40' x 6' Code: CRL-07 Weight: 44 lbs. Size: 40 feet x 6 feet Boxed size: 75" x 8" x 8" Colour: Light Green This court combines the full size play of the original tournament Roll-A-Court version but with a thinner vinyl that not only provides a cost savings, but allows the court to be set up with just one person. Recommended for indoor use, it can be used outdoors. No assembly required - simply roll out and play. When finished simply sweep the surface and roll up - easily stored for your next game. Made of vinyl, the Light Roll out Court measures a full 40' long x 6' wide. Silicone spray is not included with the court. Beads are recommended but only use plastic beads (never glass beads) and ensure no one walks on the court. (Ensure all beads are thoroughly swept up after play). For best play the official Arco brand "bevelled" discs are strongly recommended (see below). This court is ideal where there is a multi-use facility. Shuffleboard can be set up and played during its allotted time and when finished the floor can be cleared within 5 minutes - ready to use for the next scheduled event. . The regular Pro ARCO discs (OTD) will not work well on the roll out courts because they tend to "push" the beads out of the way. The special discs (OTD-B), also ARCO brand, are specially bevelled, so that they glide over the beads properly. CARE OF ROLL-A-COURT The Roll-A-Court is made of an extremely flexible Vinyl/Rubber composition and is custom colored and embossed. The thickness is less than 3/32 inch. Size is 6’ x 40’ and the lines are painted white. The courts have 2 coats of sealer applied. One thing you must be careful of: When rolling court on core leave some core at each end and line up core with deadline on court so it is straight across. Start to roll and make sure corners are tucked in properly or they will fold over. Proceed to roll to other end, and if court is not even stand on end that has core showing, hold onto loose end, let some air get in and court will slide to floor. Then tighten and tape middle and each end with duct tape. When placing in tube keep loose end of court facing up so it does not fold over. Use plastic beads sparingly, and save by collecting and runnig through a window screen to remove dirt and re-use. Glass beads of a good quality can be used (not recommended), but may require sealer applied more often as it contains some broken glass, and you must ensure that the sealer does not wear off or the surface will wear/cut and shorten life of the court. Depending on use, courts must have a thin coat of Nella-Seal applied to protect the surface. This may be required yearly but it depends on use. Sealer is applied by shaking bottle to put a puddle on court, then spreading out with an applicator. Drying time is 4 hours to roll up and 24 hours before use. If the Roll-A-Court is cared for properly you can expect many years of enjoyment.
	close window